Look up gun history by serial number smith and wesson

#Look up gun history by serial number smith and wesson cracked
#Look up gun history by serial number smith and wesson serial
#Look up gun history by serial number smith and wesson full

The cylinder gap between the rear of the barrel and the face of the cylinder is nice and tight, too.

#Look up gun history by serial number smith and wesson full

Minimal cylinder play exists when the revolver is at full cock, indicating a nicely machined cylinder stop and well-tuned action.

#Look up gun history by serial number smith and wesson serial

The classic S&W trademark logo is engraved just below the cylinder latch, and the model designation вЂњ66-8вЂќ is rollmarked on the frame inside the crane, along with the serial number. The rear sight is fit beautifully tight, without any discernible play.ДЇinished in a nice non-glare satin, вЂњSmith & WessonвЂќ runs down the left side of the barrel, вЂњ-357 Magnum-вЂќ over вЂњCOMBAT MAGNUMвЂќ down the right.

Both the top of the barrel and the rear sight base are serrated to reduce glare. It has a classic ramped front sight with an orange insert for increased visibility pinned atop the shrouded barrel.

The bore is five-groove rifled with a 1:18.75 right-hand twist. The new Smith and Wesson Model 66 has a 4.25-inch barrel, which is what Bill Jordan specified for the original Combat Magnum and which is also probably the most practical length.

#Look up gun history by serial number smith and wesson cracked

As Smith and WessonвЂ™s Paul Pluff pointed out when he first showed me the new revolver, the machining around the barrel is slightly different, leaving the frame more robust in critical high-stress areas, eliminating the potential for cracked frames. This brings us to the recent introduction of a new Smith and Wesson Model 66 Combat Magnum.В Like previous Smith and Wesson Model 66 Combat Magnums in configuration, the new revolvers have one key difference. Built with barrels varying from 2.5 to six inches in length, the former was in production from 1955 until 1999, the latter from 1971 to 2005. Two models had existed: the blued or nickel-plated carbon-steel Combat Magnum (to which the designation вЂњModel 19вЂќ was added in 1957) and the stainless steel Smith and Wesson Model 66. 357 Magnum loads for duty carry or personal protection use.ДЄmid anguished cries from revolver lovers, Smith & Wesson discontinued building the svelte K-frame. 38 Specials when practicing and reserving the heavy. Frames would occasionally crack, so shooters learned to control the diet of their beloved revolver, feeding it mostly. Over a period of time, sustained shooting of heavy magnum loads could fatigue the frame of the revolver just below the rear of the barrel, where machining for the ejector rod weakened the portion of the frame enclosing the threaded barrel.

However, time would prove that the K-frame Combat Magnum had an AchillesвЂ™ heel. The first serial-numbered gun was presented to Jordan in 1955. 357 Magnum cartridge, it sported a shrouded barrel and adjustable sights. The topic was designing the ultimate law enforcement sidearm, and the result was the Combat Magnum. 38 Special, the K frame was drafted into magnum duty by post-World War II Smith & Wesson President Carl Hellstrom after a lengthy conversation with sixgun artist and lawman Bill Jordan at the National Matches at Camp Perry. The introduction of the companyвЂ™s semiauto M&P line and the popularity of semiautos in general has made serious inroads on revolver production numbers, but that doesnвЂ™t change the fact that, in the world of legendary revolvers, those built on the K frame rank high. My revised copy of JinksвЂ™s book was printed in 1996, and at that time both statements were probably still true-and perhaps they are yet. In his 1977 book History of Smith & Wesson-considered by many to be the definitive work on the company-Roy Jinks wrote that without doubt the K-frame line of revolvers is the companyвЂ™s most important development for two reasons: Some of S&WвЂ™s most famous handguns are within the K-frame line and-a fact I was unacquainted with-вЂњвЂ¦its production exceeds the combined quantities of all the other handguns produced by Smith and Wesson.вЂќ